Regulation No 61 of the Economic Commission for Europe of the United Nations ... (42010X0630(01))
Regulation No 61 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions for the approval of commercial vehicles with regard to their external projections forward of the cab’s rear panel
- Regulation No 61 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions for the approval of commercial vehicles with regard to their external projections forward of the cab’s rear panel
- 1. FIELD OF APPLICATION AND SCOPE
- 2. DEFINITIONS
- 3. APPLICATION FOR APPROVAL
- 4. APPROVAL
- 5. GENERAL SPECIFICATIONS
- 6. SPECIFIC REQUIREMENTS
- 6.1. Ornaments, commercial symbols, letters and numbers of commercial markings
- 6.2. Headlamp visors and rims
- 6.3. Grilles
- 6.4. Windscreen and headlamp cleaning devices
- 6.5. Protective devices (bumpers)
- 6.6. Handles, hinges, pushbuttons of doors, luggage compartments bonnets, vents, access flaps and grab handles
- 6.7. Running boards and steps
- 6.8. Lateral air and rain deflectors and window anti-smear air deflectors
- 6.9. Sheet metal edges
- 6.10. Wheel nuts, hub caps and protective devices
- 6.11. Jacking points and exhaust pipe(s)
- 7. MODIFICATION OF VEHICLE TYPE
- 8. CONFORMITY OF PRODUCTION
- 9. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
- 10. PRODUCTION DEFINITELY DISCONTINUED
- 11. NAMES AND ADDRESSES OF TECHNICAL SERVICES RESPONSIBLE FOR CONDUCTING APPROVAL TESTS, AND OF ADMINISTRATIVE DEPARTMENTS
- ANNEX 1
- COMMUNICATION
- (maximum format: A4 (210 × 297 mm))
- ANNEX 2
- ARRANGEMENTS OF APPROVAL MARKS
- MODEL A
- (See paragraph 4.4 of this Regulation)
- MODEL B
- (See paragraph 4.5 of this Regulation)
- ANNEX 3
- Procedure for determining the ‘H’ point and the actual seat-back angle and for verifying their relationship to the ‘R’ point and the design seat-back angle
- 1. DEFINITIONS
- 2. DETERMINATION OF ‘H’ POINTS AND ACTUAL SEAT-BACK ANGLES
- 3. DESCRIPTION OF THE MANIKIN
- 4. SETTING UP THE MANIKIN
- 5. RESULTS
- 6. VERIFYING THE RELATIVE POSITIONS OF THE ‘R’ AND ‘H’ POINTS AND THE RELATIONSHIP BETWEEN THE DESIGN SEAT-BACK ANGLE AND THE ACTUAL SEAT-BACK ANGLE
- Appendix
- COMPONENTS OF THREE-DIMENSIONAL MANIKIN
- DIMENSIONS AND MASS OF MANIKIN
- Figure 2
- ANNEX 4
- MEASUREMENT OF PROJECTIONS AND DISTANCES
- 1. METHOD OF DETERMINING THE DIMENSIONS OF THE PROJECTION OF A PART FITTED ON THE EXTERNAL SURFACE
- 2. METHOD OF DETERMINING THE PROJECTION OF HEADLAMP VISORS AND RIMS
- 3. METHOD OF DETERMINING THE DISTANCE BETWEEN PARTS OF A GRILLE
- Figure 1
- Figure 2
- Figure 3
- Figures 4 and 5
Feedback